Amonra Energy Ad · BSESOF:AMON
Amonra Energy Ad — Technical Presentation (April 2024)
9 slides from Amonra Energy Ad's technical presentation, April 2024
Slide 1: Explode picture
Explode picture Upper cover Plastic frame Battery module Heater Heat controller BMS Bottom shell B- connector COMM connector Insulating sheet Power switch Power switch connector LED Front panel B+ connector
Slide 2: The whole frame: mold bending technology for a tougher appearance
The whole frame---Using mold bending technology, the overall appearance is tougher
Slide 3: Insulation protection
Insulation protection The entire battery pack is wrapped After opening the battery box cover, you can with insulating film, which is safe and see a black bracket insulation film, which plays reliable the role of insulation and protection. Products are safer and more reliable
Slide 4: Partition design between battery cells and voltage collection cables
Partition design between battery cells and voltage collection cables The sampling insulation bracket separates the battery cell from the voltage collection cable, eliminating the risk of short circuits between the collection cable and the battery cell collection cable, and improving safety
Slide 5: Laser welding and fixing glue for voltage collection
The power connection between the battery cells adopts aluminum laser welding to ensure reliable connection Voltage collection uses nickel sheets 9 Point laser welding, fixed with fixing glue, reliable Fixing glue connection
Slide 6: 4 way temperature sampling
4 way temperature sampling Use 4 Circuit temperature sampling, real- time monitoring of battery cell temperature to ensure the safety of battery cells during charging and discharging
Slide 7: Wide temperature range charging of -10 ℃ to 50 ℃
The battery is equipped with a heating film that can be charged at low temperatures, achieving a wide temperature range of -10 ℃ to 50 ℃ for charging One heating film on each side
Slide 8: Anti-expansion design for charge and discharge cycles
Anti-expansion design for charge and discharge cycles Steel strip The two ends of the battery pack are made of aluminum plates and tightened with steel strips to prevent irreversible expansion of the battery cells due to overheating during charging and discharging cycles, which affects the battery c
Slide 9: Thermal insulation design between cells
Thermal insulation design between cells Mica sheets have been added between both cells for thermal insulation to prevent heat from spreading between the cells, which results in better heat dissipation and can effectively Mica spacer slow down the life degradation of the cells. In addition, when the
Amonra Energy AD — Technical Presentation (April 2024) on 6ix